*Free Shipping With Every Order*
*Free Shipping With Every Order*
EBI’s Gun Holder/Accessory Hangers attaches to a variety Square Metal Tree Stands, Ground Blind Chairs, 2x4's... NO TOOLS REQUIRED. Strategically position the Base Station wherever most convenient. Simply slide the receiving end of the Base Station over the desired Square Flat Anchor Point. While being sure to allow the back / inside portion of the receiver remains square and firmly against the anchor point, tighten each of the two thumb screws clockwise until they are snug, then rotate between them back and fourth until tight. After the Base Station is secured in place, the Gun Holder's Cushioned Cradle can be adjusted to allow your Gun to remain securely in a Ready To Grip Position. Simply loosen (do not remove) the thumb screw which goes through the plate on the Gun cradle to allow the positioning locking pin to be rotated and inserted into the proper half moon adjustment hole located on the front of the Base Station. (When adjusting, be sure cradle is level/flat and parallel with the ground before placing Firearm inside and make sure pin is seated in hole before tightening). Tighten the thumb screw until tight. The Gun Holder is now ready for your Firearm.
SECURING YOUR FIREARM: When placing Firearm into cushioned cradle, be sure to center firearm in cradle ensuring even downward pressure (Trigger guard should be placed in between both cradles.)
After Firearm is in proper position, secure with rubber Gun Straps (included) when desired.
The Base Station has 2 accessory hangers to organize accessories within arms reach / out of harms way
IMPORTANT: Before each use, inspect Base Station and ensure proper
connection with its anchor point, if needed, tighten all thumb screws
EBI IS NOT RESPONSIBLE FOR THE USE OR MISUSE OF THIS PRODUCT
1. Loosen Bottom Thumb Screws to Accept Desired Flat Square Anchor Point
2. Hold Back of Base Station Flush Against Anchor Point. Tighten Bottom Thumb Screws until Snug then Alternate Between the Two Screws until Tight, Ensuring a Safe and Secure Connection
3. To Adjust Gun Cradle: Loosen Front Thumb Screw just enough to Allow Pin (Located on Back of Bracket) to Move Freely
4. Rotate Cradle Lining up Pin with Desired Angle Positioning Hole (Make Sure Parallel with the Ground) Tighten Thumb Screw
5. Hang Desired Accessories:
Range Finders, Binos, Calls,
Back packs etc. Off of Accessory Hangers
*IMPORTANT*
Keep All Firearms Secure
Before each use, inspect Base Station and ensure proper
connection with its anchor point, if needed, tighten all thumb screws
EBI Inc
Copyright © 2023 EBI Inc ( Hip Stick) - All Rights Reserved.
ebiproducts@aol.com